Skip to content

Tube fittings, valves, pipe fittings and flanges · Mogappair, Chennai

Request a quote

Tube fittings

Tube fittings and instrumentation

Double and single ferrule fittings, connectors, unions, swivels, high-pressure adaptors, thermowells and condensate pots for instrument and hydraulic lines.

Selection

Choosing the right tube fitting

Most instrument lines use two-ferrule (double ferrule) compression fittings in SS 316. They grip the tube firmly, seal on the tube and the body, and stand up to vibration and temperature cycling. Hydraulic lines built to European designs usually use single ferrule (bite-type) fittings to DIN 2353 / ISO 8434-1, while JIC 37° flare fittings are common on equipment built to American designs.

Start with the tube: its outside diameter, wall thickness and material decide the fitting size and the pressure rating. Then choose the end connection at the other side (NPT, BSPT, BSPP or metric thread, another tube end, or a weld end), the material for the medium and the environment, and any special needs such as bulkhead mounting or a swivel.

Reference

Common tube fitting types

Tube fitting types
Type What it does
Male connector Joins a tube to a female threaded port
Female connector Joins a tube to a male threaded pipe or fitting
Union Joins two tubes of the same size
Reducing union Joins two tubes of different sizes
Bulkhead union / connector Passes a tube through a panel or wall
Elbow, tee, cross Changes direction or creates branches
Port connector / adapter Converts between tube ends and thread types
Plug and cap Closes a fitting end or a tube end

FAQ

Frequently asked questions

What is the difference between single ferrule and double ferrule fittings?

Double ferrule (two-ferrule) fittings split the work between a front ferrule, which seals against the fitting body and the tube, and a back ferrule, which drives the front ferrule and grips the tube. That suits instrument lines with vibration and temperature cycling. Single ferrule (bite-type) fittings use one ferrule that bites into the tube; they are the usual choice for hydraulic lines built to DIN 2353 / ISO 8434-1.

Can I mix nuts, ferrules and bodies from different manufacturers?

We advise against it. Nuts, ferrules and bodies are designed and tested as a set, so mixing parts makes the pressure rating and leak-tightness unpredictable. Order complete fittings, and buy spare nuts and ferrules from the same series.

What tube should I use with stainless steel tube fittings?

Use fully annealed seamless or welded-and-drawn stainless steel tube, for example to ASTM A269 or A213, that is softer than the fitting and within the OD tolerance the fitting is made for. Choose the wall thickness for the working pressure. Send us the tube specification and we will confirm the match.

Which thread do I need: NPT, BSPT or BSPP?

NPT (ASME B1.20.1) and BSPT (ISO 7-1) are both tapered and seal on the thread with a sealant, but their thread forms differ (60° and 55°). BSPP (ISO 228-1) is parallel and seals with a bonded washer or O-ring. They are not interchangeable, so check the port you are connecting to.

What pressure rating do the fittings have?

The rating depends on the tube OD and wall thickness, the material and the temperature, and the tube is usually the limiting part. Tell us the tube size and the working conditions and we will quote fittings rated for the duty.

Next step

Tell us what you need

Part number, size, material or a full list: send it and get a clear quotation.