Skip to content

Tube fittings, valves, pipe fittings and flanges · Mogappair, Chennai

Request a quote

Guide

Stainless steel and alloy grade selection guide

How to choose between 304L, 316L, 321, 904L, duplex, super duplex, 6Mo, Monel, Inconel, Hastelloy, copper-nickel and titanium for fittings and flanges.

Method

Start with the medium and the temperature

Choosing a grade is a balance of corrosion resistance, strength, temperature, fabrication and cost. Begin with the medium (including trace chlorides), its concentration and temperature, the design pressure and any code or client requirements. Then pick the lowest-cost grade that is proven for that duty.

For chloride environments a useful comparison is the pitting resistance equivalent number (PREN = %Cr + 3.3 × %Mo + 16 × %N). Higher numbers mean better resistance to pitting. Typical values are about 24 for 316L, 35 for 904L and 2205 duplex, and above 40 for super duplex and 6Mo grades.

Reference

Grade families at a glance

Grade families
Family Examples Strengths Limits
Austenitic stainless 304L, 316L, 321, 347, 310S Formable, weldable, good general corrosion resistance Chloride pitting and stress corrosion cracking
High-alloy austenitic 317L, 904L, 254 SMO (6Mo) Better acid and chloride resistance Cost; welding needs care
Duplex 2205 (S31803 / S32205) About twice the strength of 316L; chloride SCC resistance Limited to about 300 °C
Super duplex S32750, S32760 Seawater pitting resistance and high strength Qualified welding; cost
Nickel alloys Monel 400, Inconel 600 / 625, Alloy 20, C276 Severe acids, high temperature, seawater Cost; availability
Copper alloys CuNi 90/10, 70/30, admiralty brass Seawater and biofouling resistance Velocity limits; sulphides
Titanium Grade 2, Grade 5 Outstanding in seawater and chlorides Cost; reducing acids

FAQ

Frequently asked questions

Is 316L always better than 304L?

For chlorides and many chemicals, yes. For plain water and many food uses, 304L performs just as well at a lower cost.

When do I need a stabilised grade such as 321 or 347?

When the steel will spend time between about 425 °C and 815 °C in service or during fabrication, where unstabilised grades can become sensitised to intergranular corrosion.

Can different grades be welded together?

Yes, with a suitable filler metal and procedure, but check galvanic effects in conductive media and any code limits.

Next step

Tell us what you need

Part number, size, material or a full list: send it and get a clear quotation.