Skip to content

Tube fittings, valves, pipe fittings and flanges · Mogappair, Chennai

Request a quote

Guide

How to install double ferrule tube fittings

Step-by-step guide to cutting, deburring, inserting and tightening two-ferrule compression fittings, with checks, remake tips and common mistakes.

Preparation

Before you start

Two-ferrule compression fittings make a reliable, leak-tight joint only when the tube is prepared and the nut is tightened correctly. Always follow the instructions for the fitting series you are using; the steps below describe the general method for two-ferrule designs.

Use fully annealed seamless or welded-and-drawn tube of the correct OD, with a wall thickness suitable for the pressure. The tube must be softer than the fitting, round, free of scratches along the sealing length, and cut square.

Step by step

Installation steps

  1. 1Cut the tube squareUse a tube cutter or a saw with a guide. A square cut lets the tube bottom fully in the body.
  2. 2Deburr inside and outsideRemove burrs and chips so they cannot damage the ferrules or contaminate the line.
  3. 3Insert the tube fullyPush the tube through the nut and ferrules until it bottoms firmly on the shoulder of the body.
  4. 4Tighten finger-tightTurn the nut finger-tight, then mark the nut at the 6 o’clock position.
  5. 5Tighten the specified turnsHold the body with a wrench and tighten the nut the number of turns specified for the series. Many two-ferrule designs use 1¼ turns from finger-tight for 1/4" (6 mm) and larger, and ¾ turn for 1/16" to 3/16" (2 to 4 mm).
  6. 6Check the make-upWhere a gap inspection gauge is supplied for the series, use it to confirm correct tightening.

Tips

Reassembly and common mistakes

Remaking a joint

  • Mark the tube at the back of the nut before disconnecting
  • Re-insert the pre-swaged tube until the front ferrule seats
  • Tighten to the original position by wrench, then slightly further
  • Replace ferrules if the tube or ferrules are damaged

Common mistakes

  • Tube not bottomed in the body before tightening
  • Mixing nuts and ferrules from different manufacturers
  • Using hard or oversized tube
  • Applying thread sealant to the tube-end nut threads
  • Over-tightening to stop a leak caused by a damaged tube

FAQ

Frequently asked questions

Do compression fittings need thread sealant?

No sealant is used on the tube-end nut. Tapered pipe threads (NPT, BSPT) on the other end of the fitting need a suitable sealant or tape.

Why do I need to bottom the tube in the fitting?

If the tube is not fully inserted, the ferrules swage at the wrong position, which can cause leaks or a tube blow-out under pressure.

How many times can a fitting be remade?

Two-ferrule fittings can usually be remade several times. Each remake needs slightly more rotation; replace the ferrules if the joint will not seal.

Next step

Tell us what you need

Part number, size, material or a full list: send it and get a clear quotation.